Skip to main content

Results appear automatically as you type.

DIY Forum
Report

Hacker Reverse-Engineers Firmware to Boot Linux on a FortiGate 60

Reading lead

A salvaged Fortinet FortiGate 60 contains a VIA C3 processor running at 400 MHz and 128 MB of soldered SDRAM. The project reverse-engineered the original firmware to determine how to initialize that memory, then made further changes that let Linux 2.4 boot. DOOM ran using the framebuffer, though the reported VGA output showed only green because only the green pin was probed. The firewall also has an internal IDE interface and CF card slot; adding physical connectors to board pads is described as a possibility, not a completed modification.

Article body

Image credit: Hackaday

When [Matt Williams] found an old enterprise firewall in the trash, he knew he had to do something with it. After cracking it open, he found that this 2000s-era Fortinet FortiGate 60 hardware firewall has some very hackable hardware in the form of a VIA C3 mainboard. This is an x86-compatible CPU that was very popular in small form-factor and industrial solutions around 2000s, meaning that it should be able to run just about anything that’s happy to run on its 400 MHz single core.

should be able to run just about anything

Unfortunately it wasn’t a standard Mini-ITX C3 board like the one that [Matt] also has kicking around, as that one features standard DIMMs for the memory modules. For this firewall the 128 MB of SDRAM was soldered to the board, with the only clue as to how to initialize it in the original firmware. Ergo this firmware had to be reverse-engineered to figure out just how this was supposed to happen.

With that done, Linux 2.4 was happy enough to boot on it with a bit more tweaking. Using the framebuffer driver applications like DOOM happily ran, as the above graphic shows. That it’s very much green is due to only the green pin on the VGA connector being probed. Since it’s a firewall Fortinet only added a physical DE-9 port in addition to the internal IDE interface and CF card slot.

If one were to wire up these pads on the mainboard to physical connectors, it would actually make for a pretty decent little system for what the kids call retro gaming these days.

Source: Maya Posch ·Hackaday · 2026-11-17T21:00:26.000Z · Read the original article

Why read this

The report documents firmware reverse-engineering and a Linux boot on repurposed hardware, but the system is an older, constrained board and the reported VGA test was limited.

AI score 52 · View scoring rationale

Two-model scores assess source reading value, not factual accuracy. Check this editorial article against the original.

  1. gpt-6-luna-2026-09-22 · 47

    The report documents firmware reverse-engineering and a Linux boot on repurposed hardware, but the system is an older, constrained board and the reported VGA test was limited.

  2. deepseek-flash · 58

    Concrete reverse-engineering of a discarded enterprise firewall to get custom firmware and Linux 2.4 booting, with specific hardware constraints (soldered SDRAM, 400 MHz VIA C3). Narrow single-board retrofitting rather than a broadly impactful change.

Analyzed: 2026.11.17 21:53 UTC

Arranged / reviewed on Zoowai · 2026.11.17 22:00

Reviewed and arranged by Zoowai editors. Original content and views belong to the source author.

0

Comments & answers 0

Sign in, rate or reply

VISA Mastercard Maestro JCB American Express Diners Club Discover