DIY Chromalux Lamp Combines a 3D-Printed Shade with Addressable LEDs
Reading lead
The featured Chromalux project, shared by luxellights on MakerWorld, is a DIY RGB lamp combining a 3D-printed base with interchangeable shade designs. Its listed electronics are an ESP8266 controller and six WS2812B LED-strip sections, each with 12 LEDs, for about 72 LEDs in total. The design calls for roughly 1.5 meters of strip with a width of 10 mm or less, and the post says a 5V, 2A USB charger is sufficient. It uses WLED firmware, installed through install.wled.me, and is configured as six segments. The project files are offered under a CC BY-NC license. The material describes a maker build and its components, not independent testing or a newly released commercial product; it provides no measured brightness, operating results, or detailed build instructions in the supplied text.
Article body
Image unavailable. Open source image ↗
Shared by luxellights on MakerWorld:
An addressable RGB LED lamp with 3D-printed base and interchangeable shade designs. Electronics: ESP8266 microcontroller, 6 strips of WS2812B (60 LEDs/meter), 12 LEDs per strip (~72 LEDs total), any strip 10mm or less in width, ~1.5m total LED strip needed. 5V 2A USB charger is plenty of power. Flashed with WLED firmware via install.wled.me, configured with 6 segments. CC BY-NC. NeoPixel/microcontroller crossover for the Adafruit audience.
Download the files and learn more
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Image unavailable. Open source image ↗
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
Source: Ben ·Adafruit Blog · 2026-10-08T21:00:17.000Z · Read the original article
Why read this
A concrete, replicable maker lamp specifies its controller, LEDs, power, and WLED setup; the material gives no independent performance tests and is not a commercial launch.
AI score 32 · View scoring rationale
Two-model scores assess source reading value, not factual accuracy. Check this editorial article against the original.
- gpt-6-luna-2026-09-22 · 34
A concrete, replicable maker lamp specifies its controller, LEDs, power, and WLED setup; the material gives no independent performance tests and is not a commercial launch.
- deepseek-flash · 31
A community 3D-print project with concrete parts (ESP8266, WS2812B strips, WLED, CC BY-NC) and modest scope; specs are self-reported with no independent verification or novel hardware release.
Analyzed: 2026.10.10 02:43 UTC
Comments & answers 0