PicoCentrifuge: A Raspberry Pi Pico DIY Centrifuge Build
导读
Maker Thomas presents PicoCentrifuge, a roughly $50 DIY centrifuge using a Raspberry Pi Pico, a drone motor and 3D-printed parts. The post says the project includes open-source code, hardware files and a bill of materials, and cites $800–$3,000 used centrifuges as a comparison. Its status is not fully clear: the roundup calls it built, while the project description says construction is underway; no performance test results are provided.
正文

配图暂未加载。 查看来源原图 ↗
Thomas the maker built an affordable (~$50) DIY centrifuge using a Raspberry Pi Pico and motors designed for drones. The project is fully open-source and includes code, hardware & BOM. Comparable commercial lab centrifuges can cost up to $3,000, making this low cost alternative appealing for makerspaces, DNA extraction demos and budget conscious teaching labs.
Thanks for sharing!
A centrifuge for blood processing, built with a drone motor, a Pico, and a 3D printer. A used lab centrifuge that fits 15 mL conical tubes goes for $800-$3,000 on eBay. That’s the most expensive piece in a DIY wet lab that otherwise costs under $500 from Amazon. I already own an A2212 brushless motor, a 30A ESC, a Raspberry Pi Pico, and a 3D printer. The physics is simple. Spin tubes in a circle fast enough that centripetal acceleration separates blood by density. PBMC isolation over Ficoll needs about 400 × g for 30 minutes with a slow coast down. So I’m building one.
See more!
Source: Ben ·Adafruit Blog · 2026-11-17T19:18:17.000Z · Read the original article
Supporting method sources
Independent sources used to review the method; availability does not establish successful operation.
方法补充来源:独立读取用于方法审核,不代表已实测运行成功。
- What We Feature on the Adafruit Blog | How to Send a Blogtip to Adafruit | Adafruit Learning System · Read / 读取日期: 2026-11-17 · Private method review only / 仅用于私有方法审核
推荐理由
The project describes a concrete centrifuge build using a Pico, drone motor and 3D printing, with files and a BOM reported. Its build status is inconsistent in the supplied text, and test evidence is absent.
AI评分 46 · 查看评分依据
双模型按来源原文评估阅读价值,不判断事实真伪;本站整理正文仍应与原文核对。
- gpt-6-luna-2026-09-22 · 40
The project describes a concrete centrifuge build using a Pico, drone motor and 3D printing, with files and a BOM reported. Its build status is inconsistent in the supplied text, and test evidence is absent.
- deepseek-flash · 52
Reports a concrete low-cost physical build (Pico plus drone motor) with claimed open-source files, but supplies no independent performance, safety or accuracy evidence; novelty is moderate and costs remain self-reported.
分析时间:2026.11.17 20:10 UTC







评论与解答 0